We have 111 guests online
Ulti Clocks content


УДК 681.121


Korobko I.

The National Technical University of Ukraine «Kyiv Polytechnic Institute», Kyiv, Ukraine ( This e-mail address is being protected from spambots. You need JavaScript enabled to view it )


MODELING OF ULTRASONIC TYPE FLOW RATE TRANSDUCERS

 

Abstract. The article is devoted to creation of effective energy saving system by means of fuel and energy resources and water measurement and assessment effective organization.
Correctness of measuring flow transducer construction principles and basic solutions, made in this, proposed to evaluate not by means of lot costly experimental testing on scale-models and laboratory samples, but realize of mathematical and virtual modeling with modern information technologies.
Estimation the selection structural parameters magnitude of ultrasonic type flow rate transducers in design and further research are considered. For comprehensive research of flow rate transducers special software to mathematic modeling was developed. Special attention is given to research of flow hydrodynamic parameters influence on meter’s metrological characteristics; to estimation of its static and dynamic characteristics; to ratio of measuring velocity to average velocity in flow and to accuracy estimation.


Keywords: flow, flow measurement, ultrasonic transducers, modeling.

 

REFERENCES

  1. Korobko І.V. Zb. Suchasnі priladi, materіali і tehnologії dlja nerujnіvnogo kontrolju і tehnіchnoї dіagnostiki mashinobudіvnogo і naftogazopromislovogo obladnannja. Іvano-Frankіvs'k: FE і ІVT, ІFNTUNG. 2008. 191 p.
  2. Kremljovskij P.P. Rashodomery i schetchiki kolichestva vewestv: Spravochnik: Kn. 1. 5-e izd., pere rab. i dop. SPb.: Politehnika, 2002, 410 p.
  3. Kremljovskij P.P. Rashodomery i schetchiki kolichestva vewestv: Spravochnik: Kn. 2. Pod obw. red. E.A. Shornikova. 5-e izd., pere rab. i dop. SPb.: Politehnika, 2004. 412 p.
  4. Prozorov M.A. Pribory i sistemy upravlenija. 1996. no 8. pp. 22 – 25.
  5. Glіnenko L.K., Suhonosov O.G. Osnovi modeljuvannja tehnіchnih sistem – Navch.posіb. L'vіv, „Beskid Bіt”, 2003. 176 p.
  6. Svan T. Delphi 7. Biblija razrabotchika. K.M.SPb.: Dialektika, 2002,672 p.
  7. Razrabotka WINDOWS prilozhenij na VisualBasic.NET i VisualC#.NET. Moskow: Russkaja redakcija, 2003, 512 p.
  8. Filatov V.I. Izmeritel'naja tehnika. 1996, no 9, pp. 36-37

 

.pdf